PLEASE NOTE THAT HELMETS ARE CUSTOM-BUILT AND TAKE 4-6 WEEKS.

Impact’s Air Draft with the Side Air Inlet offers many of the popular features found on our other Draft models, but with a side air inlet for racers looking for fresh air to be ported directly onto their face. The wicker bill design offers down-force and stability at high speeds preventing the helmet from “lifting” in open cockpit environments. A wide eye port provides an excellent field of front and peripheral vision and features a Nomex® covered eye port gasket minimizing dirt and contaminates from entering the helmet while also providing superior thermal protection. Impact’s “Intelligent Gray Matter” (a variable-density, single-piece helmet liner) is upholstered with fire-retardant soft-knit Nomex® and includes removable cheek pads. Optionally available cheek pads are available in a variety of thicknesses and configurations to provide a custom fit. The Impact Air Draft Side Air is finished with a fire-retardant Kevlar® chin strap with dual D-ring closure and 1/8” polycarbonate shield with three-position detent.

Care & Cleaning

• Please carefully read, understand and adhere to the following information. Since your helmet is engineered to very exacting standards, correct care is vital to its proper functioning.
  
  SHIELD HARDWARE: to insure proper shield fit and function, it is important to check the tightness of the shield pivot and shield positioning screws before every use. Tighten until screws are firmly seated, careful to not over tighten.
  
  HELMET CHEEK FIT PADS: to change, remove or replace cheek fit pads, turn the helmet upside down and place thumb under cheek pad and ‘pinch’ thumb with fingers on exterior shell. This will prevent separating and helmet upholstery from the shell as you remove the cheek fit pad. With free hand, slowly pull the cheek fit pad away from the hook and loop interior starting at the corner. Replace with new cheek pad.
  
  HELMET INNER LINER: after a race, wet fit pads and liner should be dried in the shade using a fan.
  
  MINI CHAMP & VAPOR HELMET INSERTS: The helmet comes from the factory as a size large without an insert. To place insert into the helmet perform the following: Hold Helmet with base opening facing you. Carefully fold back hat band upholstery toward you around the entire circumference of the helmet. Insert a Quick-Fit insert at the rear of helmet first and continue to push insert in and smooth insert down around the entire crown of the helmet. Fold hat band liner back into position.
  
  HELMET HARDWARE: all fastening hardware and straps should be checked regularly for strength and security. Keeping all components of the helmet clean and well cared for is very important. Even perspiration can compromise the effectiveness of the hardware and straps.