PLEASE NOTE THAT HELMETS ARE CUSTOM-BUILT AND TAKE 4-6 WEEKS.

Featuring Impact’s unique “Ripple Effect” aerodynamic modeling and lightweight construction, the design of the Carbon Fiber Vapor helmet provides added stability to accommodate high-speed airflow, while Impact’s integrated venting and air circulation system provides cooling comfort. In addition to our exclusive “Intelligent Gray Matter” liner (a single-piece, variable-density liner), the Vapor helmet features a fire retardant soft-knit Nomex® interior and also includes removable cheek pads. Optionally available cheek pads are available in a variety of thicknesses and configurations to provide a custom fit. Integrated crown and chin bar vents provide fog free ventilation keeping you cool and comfortable all race long. The Impact Vapor is finished with a fire-retardant Kevlar® chin strap with dual D-Ring closure and our 1/8” polycarbonate shield with three-position detent.

*Add Options like FHR Posts, an additional shield, or tear-offs below. These must be ordered as a separate item, but can be added to your new helmet by the factory if specified.

• SNELL SA2015 CERTIFIED
• Shell construction of 100% Carbon Fiber.
• Chin bar vents for needed venting and circulation.
• Tapered lower design allowing for additional clearance between the helmet and the frontal head restraint device.

Care & Cleaning

• Please carefully read, understand and adhere to the following information. Since your helmet is engineered to very exacting standards, correct care is vital to its proper functioning.
  
  SHIELD HARDWARE: to insure proper shield fit and function, it is important to check the tightness of the shield pivot and shield positioning screws before every use. Tighten until screws are firmly seated, careful to not over tighten.
  
  HELMET CHEEK FIT PADS: to change, remove or replace cheek fit pads, turn the helmet upside down and place thumb under cheek pad and ‘pinch’ thumb with fingers on exterior shell. This will prevent separating and helmet upholstery from the shell as you remove the cheek fit pad. With free hand, slowly pull the cheek fit pad away from the hook and loop interior starting at the corner. Replace with new cheek pad.
  
  HELMET INNER LINER: after a race, wet fit pads and liner should be dried in the shade using a fan.
  
  MINI CHAMP & VAPOR HELMET INSERTS: The helmet comes from the factory as a size large without an insert. To place insert into the helmet perform the following: Hold Helmet with base opening facing you. Carefully fold back hat band upholstery toward you around the entire circumference of the helmet. Insert a Quick-Fit insert at the rear of helmet first and continue to push insert in and smooth insert down around the entire crown of the helmet. Fold hat band liner back into position.
  
  HELMET HARDWARE: all fastening hardware and straps should be checked regularly for strength and security. Keeping all components of the helmet clean and well cared for is very important. Even perspiration can compromise the effectiveness of the hardware and straps.