PLEASE NOTE THAT HELMETS ARE CUSTOM-BUILT AND TAKE 4-6 WEEKS.

Do you like the value packed options and pricing of our 1320 helmet but you need something with a fresh air port? Developed in collaboration with PCI Race Radios, the 1320 OS EVO was developed as an affordable Off-Set, top-air intake helmet. Featuring the same factory-installed off-set air-port as our more expensive Carbon Fiber Air Draft OS20, the Impact 1320 OS provides continuous fresh air channeled through channels in the "Grey Matter" liner. Exiting directly above the face shield via three strategically placed air ports, cooling comfort is provided directly on to the face. Flat Black only.

• SNELL SA2015 approved.

Care & Cleaning

• Please carefully read, understand and adhere to the following information. Since your helmet is engineered to very exacting standards, correct care is vital to its proper functioning.
  
  SHIELD HARDWARE: to insure proper shield fit and function, it is important to check the tightness of the shield pivot and shield positioning screws before every use. Tighten until screws are firmly seated, careful to not over tighten.
  
  HELMET CHEEK FIT PADS: to change, remove or replace cheek fit pads, turn the helmet upside down and place thumb under cheek pad and ‘pinch’ thumb with fingers on exterior shell. This will prevent separating and helmet upholstery from the shell as you remove the cheek fit pad. With free hand, slowly pull the cheek fit pad away from the hook and loop interior starting at the corner. Replace with new cheek pad.
  
  HELMET INNER LINER: after a race, wet fit pads and liner should be dried in the shade using a fan.
  
  MINI CHAMP & VAPOR HELMET INSERTS: The helmet comes from the factory as a size large without an insert. To place insert into the helmet perform the following: Hold Helmet with base opening facing you. Carefully fold back hat band upholstery toward you around the entire circumference of the helmet. Insert a Quick-Fit insert at the rear of helmet first and continue to push insert in and smooth insert down around the entire crown of the helmet. Fold hat band liner back into position.
  
  HELMET HARDWARE: all fastening hardware and straps should be checked regularly for strength and security. Keeping all components of the helmet clean and well cared for is very important. Even perspiration can compromise the effectiveness of the hardware and straps.